Sennheiser SR 2000 IEM - ANNEXE 1 Instruction Manual page 28

Adjusting settings via the operating menu
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
26
Via the "Tune" menu item, you can:
1. set a transmission frequency to be stored in the current channel of the frequency bank
("U1" to "U6")
2. or select a frequency bank ("U1" to "U6") and a channel and assign this channel a
transmission frequency.
Setting a transmission frequency for the current channel
Turn the jog dial until the "Tune" menu item appears.
Press the jog dial.
The frequency selection appears.
PEAK PEAK Advanced Menu
0 0
Exit
-10 -10
Tune
-20 -20
-30 -30
Sync Settings
-40 -40
532.300 MHz
AF AF
Call up "Tune"
(special function)
It is vital to observe the notes on frequency selection on page 30.
Set the desired frequency.
Press the jog dial.
Your settings are stored. The "Tune" menu item appears.
Selecting a frequency bank and a channel and assigning this channel a
transmission frequency
Turn the jog dial until the "Tune" menu item appears.
Keep the jog dial pressed until the frequency bank selection appears.
PEAK PEAK Advanced Menu
0 0
Exit
-10 -10
Tune
-20 -20
-30 -30
Sync Settings
-40 -40
552.300 MHz
AF AF
Call up "Tune"
(special function)
Set the desired frequency bank.
Press the jog dial.
The channel selection appears.
Set the desired channel.
Tune
PEAK PEAK
0 0
-10 -10
552.300 MHz
-20 -20
-30 -30
-40 -40
B.Ch: U1. 1
AF AF
Select the MHz value
and confirm
"Stored"
PEAK PEAK Tune
0 0
-10 -10
552.300 MHz
-20 -20
-30 -30
-40 -40
B.Ch: U1. 1
AF AF
Select the frequency
bank and confirm
"Stored"
Tune
PEAK PEAK
0 0
-10 -10
553.300 MHz
-20 -20
-30 -30
-40 -40
B.Ch: U1. 1
AF AF
Select the kHz value;
store the setting
PEAK PEAK Tune
0 0
-10 -10
552.300 MHz
-20 -20
-30 -30
-40 -40
B.Ch: U2. 6
AF AF
Select the channel;
store the setting