Sennheiser SR 2000 IEM - ANNEXE 1 Instruction Manual page 19

Easy Setup Sync
The first unused frequency preset is
transferred from the receiver to the
transmitter.
When the transfer is completed, the
display panel of the transmitter displays
the numbers of
frequency bank and channel.
Please note that the transmitter does not
automatically store the frequency bank
and channel setting.
Place the infra-red interface of the
diversity receiver in front of the infra-red
interfaces of the remaining transmitters,
one after the other.
In each case, the next unused frequency
preset is transferred from the receiver to
the transmitter.
Either:
Store the frequency bank and channel
setting by pressing the jog dial on your
transmitters.
The RF signal is activated. You can carry
out the Sync function (see right-hand
column) at a later time to establish a
transmission link between transmitters
and receivers.
Or:
Immediately synchronize your receivers
with your transmitters by carrying out
the Sync function (see right-hand
column).
The icon in the left lower corner of
the transmitter display indicates that the
Sync function can be carried out. The
transmission link between transmitters
and receivers is established.
–
Sync
The current frequency bank and channel
setting as well as the parameters
adjusted via the
item are transferred
to the
the transferred
When the transfer is completed, " "
appears on the display panel of the
transmitter.
switches back to the standard display.
The
automatically adjusted and stored by the
receiver. The transmission link between
transmitter
established.
–
–
–
To cancel the transfer:
Press the
transmitter.
" " appears on the display panel of the
transmitter. " " also appears if no
suitable receiver was found.
Using the transmitter
"Sync Settings" menu
from the transmitter
receiver.
The transmitter
transferred parameters
and receiver is
STANDBY button on the
then
are
now
17