Sennheiser SR 2000 IEM - ANNEXE 1 Instruction Manual page 30

Adjusting settings via the operating menu
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Advanced Menu
Tune
Sync Settings
RF Power
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
28
Adjusting the transmission power – "RF Power"
PEAK PEAK Advanced Menu
0 0
Sync Settings
-10 -10
RF Power
-20 -20
-30 -30
Warnings
-40 -40
Standard
AF AF
Call up "RF Power"
Via the "RF Power" menu item, you can adjust the transmission power in three steps (Low,
Standard, High).
It is vital to observe the notes on the enclosed frequency information sheet!
Activating/deactivating warning messages – "Warnings"
Via the "Warnings" menu item, you can activate or deactivate different warning messages.
Warning message with color
Setting change on the standard display
AF Peak "AF Peak"
RF Mute "RF Mute"
Adjusting the contrast of the display panel – "LCD Contrast"
You can adjust the contrast of the display panel in 16 steps.
Resetting the settings made in the operating menu – "Reset"
PEAK PEAK Advanced Menu
0 0
LCD Contrast
-10 -10
-20 -20 Reset
-30 -30
IP-Address
-40 -40
AF AF
Call up "Reset"
When resetting the settings made in the operating menu, only the selected settings for the
pilot tone and for the frequency banks "U1" to "U6" remain unchanged. For an overview of
the factory-preset default settings, refer to the enclosed frequency information sheet.
PEAK PEAK RF Power
0 0
-10 -10
-20 -20
Standard
-30 -30
-40 -40
AF AF
Select the desired
setting
"Stored"
Trigger
Audio overmodulation
RF signal is deactivated (see page 14)
PEAK PEAK Reset
0 0
-10 -10
Yes
-20 -20
-30 -30
-40 -40
AF AF
Select the desired
setting; apply the setting
"Stored"
PEAK PEAK RF Power
0 0
-10 -10
Low
-20 -20
-30 -30
-40 -40
AF AF
Store the setting