Sennheiser SR 2000 IEM - ANNEXE 1 Instruction Manual page 29

Set the desired frequency.
Adjusting the receiver parameters and activating/deactivating their transfer to
Advanced Menu
the receiver – "Sync Settings"
Tune
Sync Settings
Via the
RF Power
EK 2000 IEM receiver.
Warnings
LCD Contrast
Menu item
Reset
IP-Address
Balance
Software Revision
Exit
Squelch
Mode
High Boost
Auto Lock
Limiter
Exit
You can specify for each parameter whether it is to be transferred to the receiver during
synchronization.
Parameter
PEAK
40 0
-10
30
-20
20
-30
10
-40
RF AF
PEAK
40 0
-10
30
-20
20
-30
10
-40
RF AF
By pressing the
transmitter to the receiver (see page 15).
Press the jog dial.
The frequency selection appears.
Press the jog dial.
Your settings are stored. The "Tune" menu item appears.
"Sync Settings" submenu, you can adjust the following parameters for the
Transferred receiver parameter
Balance or Focus setting ("−15"/"+15")
Squelch setting ("5 dB" ...
Audio mode setting ("Stereo"/"Focus")
Treble boost setting for output signal
Lock mode setting ("Active"/"Inactive")
Limiter setting ("−18
Exits the "Sync Settings" submenu and returns to the extended menu
"Advanced Menu"
Transfer is ...
... deactivated
-60 dB
Sync
... activated
-60 dB
Sync
button on the transmitter, the parameters are transferred from the
Adjusting settings via the operating menu
"25 dB")
("flat"/"High
dB", "−12 dB", "−6 dB", "Off")
boost" (8 dB at 10 kHz))
27