Using Freely Selectable Transmission Frequencies - Sennheiser SR 2000 IEM - ANNEXE 1 Instruction Manual

Operation without First carry out the
network The transmitter is set to a suitable frequency.
Then carry out the
page 16, right-hand column).
This establishes a transmission link between the transmitter and the receiver.

Using freely selectable transmission frequencies

You can also freely select the frequencies and store these frequencies in the frequency banks
"U1" to "U6".
If you want to use the frequency banks "U1" to "U6":
Make sure to use transmitters and receivers from the same frequency range (see page 4
and the type plates of the devices).
Set each transmitter to the same frequency bank.
On one of the transmitters, select a channel within this frequency bank (see page 25).
Assign this channel one of the calculated transmission frequencies (see page 25).
Synchronize a receiver with your transmitter (
OR
Manually set the receiver to the same frequency bank, channel and frequency that you set
on the transmitter.
Repeat for the remaining transmitters and receivers as described above.
Synchronizing the transmitter with the EK 2000 IEM receiver
Easy Setup Sync
Sync function once for each transmitter/receiver pair (see table on
To ensure that the desired frequencies are intermodulation-free:
Contact your Sennheiser partner (see www.sennheiser.com).
function (see table on page 16, left-hand column).
, see page 16).
31