Muting The Audio Signal Or Deactivating The Rf Signal - Sennheiser evolution wireless G3 500 Series Instruction Manual

Muting the audio signal or deactivating the RF signal

EM 500
To mute the audio signal:
When one of the standard displays is shown on the display panel, press the
STANDBY button.
"RX Mute On?" appears on the display panel.
Press the jog dial.
The audio signal is muted.
standard display.
To unmute the audio signal:
Press the STANDBY
"RX Mute Off?" appears on the display panel.
Press the jog dial.
The muting is canceled.
SK 500
·
·
The MUTE switch allows you to mute the audio signal or to deactivate the RF signal. Via the
"Mute Mode" menu item, you can set the desired function of the
Slide the MUTE switch · ...
Setting
"Disabled" ... to the left (position MUTE)
"RF On/Off" ... to the left (position MUTE)
... to the right
"AF On/Off" ... to the left (position MUTE)
... to the right
From the "Mute Mode" menu item, select the desired setting (see page 28).
Exit the operating menu.
Slide the MUTE switch
The bodypack transmitter reacts as indicated in the table.
The current state of the muting function or the RF signal is displayed on the display panel of
the bodypack transmitter. An additional display appears on the receiver's display panel when
the pilot tone function is activated on both bodypack transmitter and receiver and, in addi-
tion, this display has been activated via the "Warnings" menu item on the receiver (see
page 27).
"RX Mute" appears in alternation with the current
button.
AF
·
to the left, to the position MUTE.
Using the devices
MHz
543.200
ew500 G3
P
MUTE
switch ·:
MUTE
Function
None
Deactivates the RF signal
(offline operation)
Activates the RF signal
(online operation)
Mutes the audio signal
Unmutes the audio signal
23