Ethernet Connection To One Computer - THOMSON TWG850 User Manual

Chapter 1: Connections and Setup

Ethernet Connection to One Computer

Make the connections to the modem in the following sequence:
1. Connect one end of the coaxial cable to the cable connection on the wall, and the other end to
the CABLE jack on the Residential Voice Gateway.
2. Connect the plug from the AC power supply into the POWER AC ADAPTER jack on the
Residential Voice Gateway, and plug the power supply into an AC outlet.
Note: Use only the power supply that accompanied this unit. Using other adapters may damage
the unit.
3. Connect one end of the Ethernet cable (straight-wired, see below) to the Ethernet port on the
back of your computer, and the other end to the ETHERNET port on the Residential Voice
Gateway.
Make sure that the Ethernet cable is straight-wired (not "null" or crossover-wired). However,
you will need a crossover-type cable if you are connecting the modem to a hub, or a hub
within a port switch that provides the same function.
20
Fig.3: Ethernet Connection