Important Connection Information; Ethernet Connection To A Computer - THOMSON TCW750-4 Instruction Manual

Important Connection Information

The Wireless Gateway supports Ethernet connections simultaneously.
Below are important points to remember before you connect the Wireless Gateway.

Ethernet Connection to a Computer

Make the connection to the modem in the following sequence:
1. Connect one end of the coaxial cable to the cable connection on the wall, and the other end to the
CABLE jack on the Wireless Gateway.
2. Connect the plug from the DC power supply into the POWER DC ADAPTER jack on the Cable
Wireless Gateway, and plug the power supply into a DC outlet.
Note: Use only the power supply that accompanied this unit. Using other adapters may damage the unit.
3. Connect one end of the Ethernet cable (straight-wired, see below) to the Ethernet port on the back of
your computer, and the other end to the ETHERNET port on the Wireless Gateway.
Make sure that the Ethernet cable is straight-wired (not "null" or crossover-wired). However, you
will need a crossover-type cable if you are connecting the modem to a hub, or a hub within a port
switch that provides the same function.
Illustrations contained in this document are for representation only.
Chapter 1: Connections and Setup
Fig.2: Ethernet Connection
10