Pre-Maintenance Procedures; Preparing The Machine For Maintenance; Using The Bed Support - Toro Workman 07390 Operator's Manual

Pre-Maintenance
Procedures
Preparing the Machine for
Maintenance
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Empty and raise the cargo bed; refer to
the Cargo Bed (page
4. Shut off the engine and remove the key.
5. Allow the machine to cool before performing
maintenance.

Using the Bed Support

Important:
Always install or remove the bed
support from the outside of the bed.
1. Raise the bed until the lift cylinders are fully
extended.
2. Remove the bed support from the storage
brackets on the back of the ROPS panel
28).
Figure 28
1. Bed support
3. Push the bed support onto the cylinder rod, and
ensure that the support-end tabs rest on the
Raising
25).
(Figure
g026142
end of the cylinder barrel and cylinder-rod end
(Figure 29).
1. Bed support
2. Cylinder barrel
4. Remove the bed support from the cylinder, and
insert it into the brackets on the back of the
ROPS panel.
Important:
Do not try to lower the bed with
the bed-safety support on the cylinder.
35
Figure 29
3. Bed
g009164