Figure 69. Removing the optional IDSDM module
NOTE:
There are two dip switches on the IDSDM module for write-protection.
Next steps
Install the optional IDSDM/vFlash card.
Installing optional IDSDM or vFlash card
Prerequisites
Follow the safety guidelines listed in
Steps
1. Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash connector, see the
2. Align the IDSDM/vFlash card with the connector on the system board.
3. Push the IDSDM/vFlash card until it is firmly seated on the system board.
88
Installing and removing system components
Safety instructions
on page 34.
System board jumpers and connectors
on page 137 section.