Installing the USB module
Prerequisites
Follow the safety guidelines listed in
NOTE:
The procedure to install the USB 3.0 and USB 2.0 modules is similar.
Steps
1. Route the USB cable on the USB module, through the USB slot on the front panel.
2. Insert the USB module into the slot on the front panel.
3. Align the screw on the module with the screw hole on the system.
4. Using the Phillips #1 screwdriver, replace the screw to secure the module to the system.
5. Route the USB cable and connect it to the USB connector on the system board. For more information, see the System board
jumpers and connecters section.
Figure 107. Installing the USB module
Next steps
1.
Install the air
shroud.
2.
Install the backplane
cover.
3. Follow the procedure listed in
VGA module
Removing the VGA module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the front bezel
116
Installing and removing system components
Safety instructions
on page 34.
After working inside your system
Safety instructions
Before working inside your system
on page 35.
on page 34.
on page 35.