Appendix 6 Frequently-Asked Questions - Datavideo HS-4000 Instruction Manual

Appendix 6
This section describes problems that you may encounter while using the HS-4000. If you have
any questions, please refer to related sections and follow all suggested solutions. If problem
still exists, please contact your distributor or the service center.
No. Problems
1 Why isn't the logos transitioned?
2 Is there any other way alternative to
GUI to reset the machine's IP
address?
Frequently-Asked Questions
Solutions
Logos will not be transitioned as the CUT
or AUTO button is pressed, nor will it be
transitioned as the T-bar is pushed.
Use a needle to push the reset hole next
to the USB FW Upgrade port to restore
the default IP address. Push the reset
button then hold for about 5 to 10
seconds until the machine reboots itself to
restore the IP address to 192.168.100.101.
174