Table of Contents
Advertisement
Frequently-Asked Questions
This section describes problems that you may encounter while using the SE-700. If you have questions, please refer
to related sections and follow all the suggested solutions. If problem still exists, please contact your distributor or
the service center.
No.
Problems
1.
In the Still option, images are sometimes
distorted if they are captured from live video
fed into Inputs 1-4.
2.
Is CUT transition available for DSK function?
3.
What are the expected behaviors of
PIP/LUMA/DSK buttons?
4.
Why can't image captured using the Freeze
function be found after the SE-700 is
restarted?
5.
Can PIP/KEYER/DSK be enabled at the same
time?
6.
Why is PGM DSK1 showing the same output
as PGM in Setup -> Outputs?
7.
720p Video output on HDMI-1 cannot be
displayed on TLM-700HD.
8.
Menu scroll is only one-direction, i.e. once the
end of the list is reached, the user should
reverse the direction of the scroll to go back
to another end of the list.
9.
Is there any other indication of PIP/Keyer/DSK
enable?
Solutions
It is recommended to use still images in the Still
option.
DSK function does not support CUT transition.
PIP PVW/LUMA PVW/DSK PVW Button ON: Effect
displayed on PVW Screen; after configuring
parameters of PIP/LUMA/DSK, enable PIP
PGM/LUMA PGM/DSK PGM to switch
PIP/LUMA/DSK to PGM Screen (or the user can use
CUT or T-Bar to perform transition; CUT is not
available for DSK though)
If only PIP PGM/LUMA PGM/DSK PGM are enabled,
then the effect is displayed on both PVW and PGM
screens.
Image captured using the Freeze function will be
lost after power is switched off.
Yes, PIP/KEYER/DSK can be enabled at the same
time with PIP at the bottommost layer, Keyer in the
middle and DSK on the topmost layer.
DSK2 is not available on the SE-700 so PGM DSK1 is
same as PGM.
Please use TLM-170H/170P/434H for such
application.
Some of the menu options allow the user to cycle
through the list, whereas other menu options are
one-direction.
There are two indications of PIP/Keyer/DSK enable:
1. There are tally indications for channels set to key
and fill sources of PIP/Keyer/DSK.
Advertisement
Table of Contents
