Encoder - Datavideo HS-4000 Instruction Manual

CODEC Unknown Error
SD Card Write Error
SD Card Full
Firmware Update
Failure
SD Card Format Failure
The status codes are listed in the table below.
Status
No Error
Initiating
Working
F/W Updating
F/W Update Successful
SD Card Format
Successful

Encoder

Click the Encoder tab to open the encoder configuration page.
First select an appropriate video bitrate mode from the Encoder Mode drop-down list for
video streams and the recorder. The modes are high, mid and low which provide quick
access to suggested video bitrate combinations across the encoder and the recorder.
241 CODEC unknown error
240 SD card write error; compatibility
issue
238 SD card full
237 Firmware update failed
236 SD card cannot be formatted
Code
000 Record/Stream stopped without
error.
001 Record/Stream is initializing.
002 Recording/Streaming in progress
007 Firmware is updating.
009 Firmware update is successful.
010 SD card is formatted successfully.
148
Descriptions
Record/Stream
Record Only
Record Only
System
System
Impact
Record/Stream
Record/Stream
System
System
System