Mode Button; Res Button; Bitrate Button - Datavideo HS-4000 Instruction Manual

Solid Red

MODE Button

Press the MODE button to select the device's mode of operation. The
available modes are listed as follows:
 STM+REC: Stream and record simultaneously
 STM ONLY: Stream only
 REC ONLY: Record only
The LED indicator of the selected mode of operation should turn ON.
Please note that when STM+REC is selected, you can only set either one of the stream and
record channels to 4K or both channels to HD. Use the RES button to select resolution.

RES Button

Press the RES button to switch between 4K and HD resolutions.
The LED indicators should indicate the resolution selected for the stream and
record channels.

BITRATE Button

Press the BITRATE button to select the bitrate mode for video streaming and recording. The
available bitrate modes are listed as follows:
 H: High
 M: Moderate
 L: Low
Note: The default bitrate is M.
The correlated video bitrates of the encoder and the recorder in each mode are summarized
in the table below:
Modes Encoder
Low 6 Mbps
Medium 8 Mbps
High 10 Mbps
You can also change the video bitrate using the web user interface, see
Resolution
Mode change
change in
in progress
progress
Recorder
20 Mbps
30 Mbps
40 Mbps
164
Push and hold
Bitrate for at least 2
change in seconds to stop
progress device
operation.
Encoder for details.