Table of Contents
Advertisement
Frequently-Asked Questions
This section describes problems that you may encounter while using the SE-700. If you have questions, please refer
to related sections and follow all the suggested solutions. If problem still exists, please contact your distributor or
the service center.
How to use the P-in-P Keyer function?
1. Connect a source with a green backdrop
2. Press and hold "PIP PVW" button and select an input source from the preset row
3. Press "PIP PGM" button to open the PIP window on PGM Screen
4. Press "PIP SETUP" button to open the P-in-P Setting window
5. Set the XY coordinates and the PIP window size to your preference
6. Go to P-in-P Keyer setting menu and configure the following to achieve chromakeying of the green backdrop
•
P-in-P Src: Select an input source
•
Keyer: Chroma
Keyer CTRL: Lift 0 / Gain 0 / OPAC 100
•
•
CK Matte: HUE 120~125 / LUMA 100
CK Key: K ACC 140 / K Lift 10 / K Gain 16
•
How to use the Keyer function?
1. Connect a source with a green backdrop
2. Press and hold "KEYER PVW" button and select an input source from the preset row
3. Press "KEYER PGM" button to display the selected source on PGM Screen
4. Press "KEYER SETUP" button to open the Keyer Setting window
5. Configure the following to achieve chromakeying of the green backdrop
Keyer: Chroma
•
•
Keyer CTRL: Lift 0 / Gain 0 / OPAC 100
•
CK Matte: HUE 120~125 / LUMA 100
•
CK Key: K ACC 140 / K Lift 10 / K Gain 16
Can we save the PGM image captured using the GRAB function to the SD card?
Currently the PGM image captured using the GRAB function is saved temporarily to INPUT 6 and will be lost once
the SE-700 is powered off. Future firmware release will allow the user to permanently save the PGM image
captured using the GRAB function to the SD card.
37
Advertisement
Table of Contents
