Positioning Control; Types Of Positioning Controls - Panasonic FP7 User Manual

10.10 Positioning Control

10.10.1 Types of Positioning Controls

■
Operation pattern
Name Time chart
E-
point
contro
l
P-
point
contro
l
C-
point
contro
l
No speed change
J-
point
contro
Speed changes
l
■
Selection of positioning operation modes
Positioning operation modes are selected on Configurator PMX.
WUME-FP7MXY-06
10.10 Positioning Control
Operation and application
● This is a method of control which is
initiated up to an end point, and is
referred to as "E-point control".
● This method is used for a first
speed acceleration/deceleration.
● This refers to control which passes
through a "Pass Point", and is
called "P-point control".
● This method is used for a second
speed acceleration/deceleration.
● After the pulse output is performed
for a specified movement amount,
it shifts to the E-point control.
● This refers to control which passes
through a "Continuance Point", and
is called "C-point control".
● This method is used for performing
two successive first speed
positioning control with different
target speeds or acceleration/
deceleration times.
● The time taken for transmitting
from the C-point control to E-point
control is specified as a dwell time.
● This refers to control which passes
through a speed point "JOG
Operation Point", and is called "J-
point control".
● After the start, it is controlled at
specified speeds.
● Once the J-point positioning
contact turns on, the positioning
control starts.
● When the J-point control speed
change flag is set, the speed
changes.
Inter-
Repea
pola-
t
tion
A A
A A
A A
- -
10-47