Pcie Riser Assembly And Adapter; Replacement - Lenovo ThinkSystem SD550 V3 User Manual

Figure 89. Installation of rear OCP module
After this task is completed
1. Power on the node (see
2. Proceed to complete the parts replacement (see
PCIe riser assembly and adapter replacement
Follow instructions in this section to remove or install the PCIe riser assembly and PCIe adapter.
Notes:
• Depending on the specific configuration, the node might not come with this component.
• When there is no PCIe riser assembly installed in the node, make sure to install a PCIe riser filler on the
rear of the node.
Remove the PCIe riser assembly
Follow instructions in this section to remove the PCIe riser assembly.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention: Read "Installation Guidelines" on page 43
sure that you work safely.
Note: Depending on the specific configuration, the hardware might look slightly different from the
illustrations in this section.
Procedure
ThinkSystem SD550 V3 User Guide
146
"Power on the node" on page 53).
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 44
208).
to make