Room Averaging Using Occupancy Detection; Occupancy Sensor Setting; Lennox Wireless Extender; Adding And Removing The Lennox Wireless Extender - Lennox S40 User Manual

• Selecting Sensor Settings will allow the homeowner to include or exclude
a specific Smart Room Sensor from temperature averaging. Listed in this
section are Sensor name, Sensor type and About Sensor. Selecting
Sensor Name will allow renaming of the sensor, if desired.

Room Averaging using Occupancy Detection

The following two features can be set using either the thermostat or thermostat
app using the system setting screen.
From the Home screen, go to Menu > Settings > Current Temperature.
Back
System Info TV Room
Settings
Wi-Fi
Away
Current Temperature
Fan
Heat/Cool
Humidity
iHarmony Zoning
Notifications
Peak Monitoring
Ventilation
Devices
TSTAT
Battery Sensor
Light Switch
Figure 23. Occupancy Settings for Temperature Averaging

Occupancy Sensor Setting

The occupancy detection feature is built into every sensor. The settings are
as follows:
• OFF - When the occupancy feature is turned OFF, the thermostat will
always include the sensor in temperature averaging.
• ON - When the occupancy feature is turned ON, the thermostat will only
include the sensor in temperature averaging if the room is occupied.
Sensor Temperature Difference Limit
This feature for temperature averaging limits how much of a difference in
temperature readings there can be by comparing any Smart Room Sensor
detected temperature to the Lennox
temperature. By default, if the Smart Room Sensor temperature reading
difference is less or greater than 7ºF, it will be excluded from participating in
temperature averaging.
The message "Device is not participating as temperature readings are
abnormally high/low" will appear at the bottom of the Smart Room Sensor
Detail screen.
System Settings TV Room
Current Temperature
Feels Like Off
Participating Sensors in Temperature Averaging Based on Occupancy
Thermostat Off
Laura's Room On
TV Room
On
S40 Smart Thermostat detected
®
Verify that the sensor is not in direct sunlight, discharge vents, unconditioned
space or any other types of environmental conditions that could affect the
Smart Room Sensor temperature reading.
NOTE: If the Smart Room Sensor is in a suitable location and the actual
room temperature does not match what the sensor is reporting, then
the Smart Room Sensor may need to be replaced.

Lennox Wireless Extender

Adding and Removing the Lennox Wireless Extender

Please refer to the Smart Room Sensor Setup and Installation guide
for information on the devices, placement and pairing using the Lennox
Thermostat App to the S40 Smart Thermostat.

View and Understanding the Wireless Extender Detail Screen

From the thermostat's Home screen, select the My Home option. Then
select the wireless extender icon. This will display the details for that wireless
extender.
Wireless Signal strength indicators are illustrated as follows:
Figure 24. Wireless Extender Signal Strength Indicators
39