Adjusting Room Temperature, Away Mode, Program Change, Clock And Weather - Lennox iComfort Wi-Fi® Thermostat Owner's Manual

Adjusting Room Temperature, Away Mode, Program Change, Clock and Weather

Adjust temperature when programming is OFF —
programming is OFF, the system mode button (shown in figure 20, labeled
heat or cool) indicates a manual mode (no mention of "program"). In this
mode, touch one of the two set temp buttons to change the temperature
setting. The up/down arrows appear, allowing you to adjust the "cool to" (or
"heat to") values to the desired temperature setting.
This setting will remain until you decide to change it again. (The inset shows
an alternate configuration of button layout in non-program mode.)
indoor temperature set temp
75
cool-to
70
heat to
indoor humidity is 41%
touch
cool-to
button
system is cooling
Wi-Fi 9:39 am May 23, 2012
Figure 20. Adjusting Temperature with NO Program Running
Away Mode (Vacation) —
screen (upper right-hand corner) sets the system for manual operation and
allows you to set the thermostat for energy-saving operation while you are
gone for an extended period of time. In this mode, the system will only come
on if the indoor temperature falls below a set value in the heating mode (62º F
default), or if the indoor temperature rises above a set value in the cooling
mode (85º F default). You may adjust these settings as desired (see figure
21). To exit the away mode, touch cancel away mode.
507342-01
(system
enter
mode button)
away
heat
or
cool
set temp
fan is
75
AUTO
fan is fan is
AUTO OFF
cool-to
use arrows
to change
temperature
alternate
cool-only button
layout
? ?
The enter away mode button on the home
When the
9:39 am May 23, 2012 9:39 am May 23, 2012
Wi-Fi
cool
only
Figure 21. Adjusting Temperature with Program Running
fan is
AUTO
Turn Programming ON —
system mode button (shown in figure 22, labeled heat or cool) to open the
manual settings menu. Programs is the final selection in this menu. Select
programs to display the program settings menu. (The menu will disappear if
you don't make a selection within a few seconds). Select an option (e.g.
spring/fall). The system mode button will display the selected program (e.g.
spring...program is ON).
Turn Programming OFF —
system mode button (e.g. spring...program is ON) to return to manual
mode. The program settings menu includes an option for manual. Select
manual to display the manual settings. Select one of the manual settings
(e.g. heat only). After the selection is made, the system mode button will
display the selected manual option (e.g. heat only).
Page 14
system is currently using energy saving AWAY settings
indoor temperature set temp
82
cool-to
60
heat to
use arrows to
change
temperature
(Away Mode)
If the programming is OFF, touch the
If the programming is ON, touch the
cancel
away
? ?