Panasonic LQ-D100P Operating Instructions Manual page 39

Operation
6-2. Copy settings
1. Proceed with the copy settings on the DISC COPY
setup menu. First, check the SCSI connection and
external drive.
When EXT-DRIVE CHECK is executed, the SCSI
connection and external drive are checked.
< DISC COPY >
EXT-DRIVE CHECK
<EXECUTE>
~ DRIVE INFORMATION -
INTERNAL DRIVE
TYPE «COMPONENT>
USED: 250
EXTERNAL DRIVE
OK
REMAINS :
NO-CHECK
XXXX
SELECT <4 ®aW> EXIT <MENU> / SAVE <SET>
If the checks turn out to be OK, the disc information
of the external drive is displayed together with the
setting items as shown below. The external drive's
tray is locked at this time. (in order to prevent
accidents during copying, the tray button of the
external drive is disabled.)
< DISC COPY >
EXT-DRIVE CHECK
COPY-MODE
TRAY-UNLOCK
<EXECUTE>
INHIBIT
<EXECUTE>
- DRIVE INFORMATION -
INTERNAL DRIVE
TYPE <COMPONENT>
USED: 250
EXTERNAL DRIVE
TYPE <COMPONENT>
USED: 0
OK
REMAINS: XXXX
OK GAANA
REMAINS : XXXX
SELECT -ABAYS
EXIT <MENU> / SAVE <SET>
39
2. Select the COPY-MODE setting.
INHIBIT:
This disables copying.
MANUAL:
This sets the unit to the manual copy mode.
Select the required frame from the copy source
disc and copy it. If a frame has already been
recorded on the copy destination disc, this
required frame is also copied.
PROGRAM:
This sets the unit to the program copy mode.
While program playback is being performed, the
frames are copied in program seguence from the
copy source disc. if frames have already been
recorded on the copy destination disc, these
frames are also copied.
DUPLICATE:
This sets the unit to the duplicate mode. The
contents of the copy source disc are copied onto
the copy destination disc in their original format.
Any frames already recorded on the copy
destination disc will be overwritten and erased
during this process. The DUPLICATE setting is
used to make backups (copies) of discs.
Upon compfetion of the settings, press the SET
button to close the setup menu. When the unit
goes into the copy mode, its REC lamp flashes.
„Start copying. As operation differs according to the
copy mode, refer to the items on the next page for
specific details.
. Release the copy mode.
Open the DISC COPY setup menu, and select
EXECUTE
as the TRAY-UNLOCK
setting.
This
enables the external drive's tray to be opened and'
closed (unlocked), and at the same time it releases
the copy mode.