Table of Contents
Advertisement
General Introduction
@ Cursor buttons (up, down, left and right arrow
buttons)
These buttons are used to move the cursor and
input data so as to set the search conditions and
perform setup menu and other operations.
The
functions
below
are executed
when
these
buttons
are
pressed
together with the SHIFT
button.
Up arrow button (CHARACTER):
When alphanumerics or other characters need to
be input, press this button while holding down
the SHIFT button. The character input mode is
now established. The character selection screen
for inputting the characters now appears on the
TV monitor. (See page 66.)
Down arrow button (OVERWRITE):
When
this button is pressed during playback
while holding down the SHIFT button, the unit
goes into the recording mode in which the frame
currently being played back is overwritten. The
frame is overwritten in the same way as with
normal recording, and once another frame has
been recorded in its place, the unit automatically
exits the mode.
Left arrow button (VOICE PLAY):
When this button is pressed during playback
while holding down the SHIFT button, a voice
memo corresponding to the frame being played
back is played back for about 5 seconds.
The
VOICE lamp flashes green during playback.
Right arrow button (VOICE REC):
When this button is pressed during playback
while holding down
the SHIFT
button,
it is
possible to record a voice memo lasting about 5
seconds for the frame being played back. The
VOICE
lamp
lights up green
or red during
recording.
@ "+" button and "~" button
These buttons are used for inputting numbers when
the setup menu is displayed.
They are also used to scroll the pages up or down
when the search results or multi-screen display is
shown.
The following functions are executed by pressing
the buttons while holding down the SHIFT button.
"+" button (END):
l
When this button is pressed while holding down
the SHIFT button, an end search which locates
the address
of the last recorded
frame
is
performed.
"—" button (ID):
;
When this button is pressed while holding down
the SHIFT button, the settings related to the IDs,
which are added to the images during recording,
can be performed.
16
OSET button
This is used to enter the operations such as the
setup menu operations.
O CLR button
This is used to cancel (clear) an operation.
(D WRITE ONCE lamp
"This lights when a disc has been formatted in the
pseudo write-once mode.
@ DUAL lamp
This lights when the dual-picture recording mode
has been selected.
(O NEXT lamp
This lights when the NEXT mode has been selected.
( SYSTEM lamp
This flashes when a caution or warning is issued or
trouble has occurred in the system.
it is turned off
by the CLR button.
Advertisement
Table of Contents
