Table of Contents
Advertisement
General Introduction
2-3. NEXT mode
1. Outline of functions
In the NEXT mode, the frame which is to be output
next is previewed to the monitor output connector so
that it can be checked before it is played.
e The
NEXT
mode
functions
only
when
the
Component mode has been established.
The
NEXT
mode
is set ON
or OFF
in the
Component
mode
using the PLAY
item on the
setup menu.
Kia
RGB mode
Component mode
Norma! playback mode
Enabled
Enabled
NEXT mode
Disabled
Enabled
The
same
operation
is performed
for INPUT,
FREEZE and REC whether the NEXT mode is set
ON or OFF.
e During playback, the frame with the current address
(hereafter referred to as the "current frame") is
output to the output connectors other than the
monitor output connector (hereafter referred to as
the "main output connectors") while the frame with
the next address (hereafter referred to as the "next
frame") is output to the monitor output connector.
By pressing the FORWARD
button, for example,
the main output is switched from the current frame
to the next frame.
During playback, it is possible to change only the
next frame without making any changes to the
current frame.
The next frame oniy can be forwarded or reversed
using the "+" or "—" button. Direct search also works
for the next frame.
This function enables the next frame to be replaced
with another frame without changing the current
frame.
<Note>
In the INPUT or FREEZE
mode, the frame is not
changed by the "+" or "-" button.
When a direct
search is conducted, the selected frame is output to
the main output connectors.
At this time, the frame
next to the selected frame is output to the monitor
output connector.
11
è Multi-screens in the NEXT mode are output to both
the main and monitor output connectors.
When a frame is selected on a multi-screen during
playback and the FORWARD
button is pressed, the
selected
frame
is output to the monitor
output
connector, and the next frame which was previously
output to the monitor output connector
is now
output to the main output connectors.
When a frame is selected on a multi-screen in the
INPUT
or FREEZE
mode
and the FORWARD
button is pressed, the selected frame is output to
the main output connectors.
At this time, the frame
next to the selected frame is output to the monitor
output connector.
If trouble occurs when a multi-
screen
is output to the main output connectors
during playback, the multi-screen
in the NEXT
mode can be prohibited by a setup menu
item
setting.
2. NEXT modes 1 and 2
When it comes to the method used to display the
setup menu and the search screen, there are two
NEXT modes, NEXT modes 1 and 2. One of these
two modes is selected using the "NEXT
1/2" DIP
switch (bit 5) on the unit's rear panel. When mode 1
is off, mode 2 is on.
O NEXT mode 1
In this mode, the setup menu
displays do not
appear at the main output connectors (all the output
connectors except the monitor output connector).
e The search screens and setup menus are output
to the monitor output connector only.
e The on-screen displays in the INPUT or FREEZE
mode
are also output to the monitor output
connector only.
e The on-screen displays of the frame addresses,
dates and times, etc. during playback represent
the information on the monitor output frame (next
frame).
GO NEXT mode 2
In this mode, the setup menu and other displays
appear as usual.
@ The search screens and setup menus are output
as usual with the same signals going to both the
main and monitor output connectors.,
e The on-screen displays of the frame addresses,
dates and times, etc. during playback represent
the information on the monitor output frame (next
frame}.
Advertisement
Table of Contents
