Table of Contents
Advertisement
Operation
5. Voice memo
recording/playback
This function is used to record 5-second voice memo
and add them to the frame.
5-1. Preparations
1. Connect the microphone to the MIC jack on the
front panel, and connect the headphones to the
PHONE jack.
5-2. Recording voice memos
1. Play back the frame whose voice memo
is be
recorded.
it is not possible to record a voice memo unless the
frame whose voice memo is to be recorded is
played back for selection.
ft
. Start recording.
Press the right arrow button while holding down the
SHIFT button.
The VOICE lamp lights for 5 seconds.
Speak into
the microphone during this period.
5-3. Playing back voice memos
|
1. Play back the frame whose voice memo is to be
played back.
N)
. Play back the voice memo.
Press the left arrow button while holding down the
SHIFT button.
The VOICE lamp flashes for 5 seconds, and the
voice memo is played back.
Use the VOL control to adjust the volume.
5-4. Playing back voice memos and
frames simultaneously
„Select the playback operation mode for the voice
memos.
Set VOICE on the PLAY setup menu in such a way
that the voice memo is played back at the same
time as the frame is played back.
-h
NI
„When ON has been set, the voice memo is played
back for 5 seconds at the same time as the frame is
played back.
38
6. Copying discs
The disc copy function serves to copy frames and
back up discs once an external DVD-RAM drive has
been connected to the unit.
6-1. Preparations for copying (preparing
the external drive)
Turn off the power, and connect the external DVD-
RAM drive using the SCSI cable.
Perform the SCSI-related settings.
è Set the "TERMINATOR" DIP switch on the unit's
rear pane! to OFF.
e Set the TERMINATOR
switch on the external
drive to ON, and the SCSI ID to "1."
1.
. Turn on the power of the external drive first, and
then turn on the unit's power.
„Insert the copy source disc into the unit's drive and
a formatted disc (copy destination disc) into the
external drive.
The
disc used
in the external
drive must
be
formatted using the same recording format as the
copy source disc.
Discs cannot be formatted by the external drive.
Ensure that the disc has been formatted by the unit
before proceeding.
<Note>
The DVD-RAM drive contained in the computer can
also be used as the externa! DVD-RAM drive.
For using the DVD-RAM drive of the computer instead
of the external drive, it is necessary to set the SCSI-
IDs and the terminators property according to the
information below.
è the SCSI-ID of the internal drive in LQ-D100 is O.
ə the SCSI-ID of the host adapter in LQ-D100 is 6.
e the SCSI-ID of the copy destination drive must be
1.
So, the SCSI-ID
of the DVD-RAM
drive
in the
computer must be set to 1 and the host adapter and
the other SCSI equipments in the computer have to
use the SCSI-IDs except 0, 1, 6.
CAUTION:
When
the
DVD-RAM
drive
in the
computer
is
connected with the LQ-D100, do not access the DVD-
RAM drive from the computer.
The LQ-D100 discs
may be destroyed.
Advertisement
Table of Contents
