Table of Contents
Advertisement
General Introduction
3-2. Rear panel connector area
@RGB/composite/component
(Y, Ps, Pr) video
input connectors
(BNC
x3) and
SYNC/REF
VIDEO connector (BNC x1)
RGB mode:
The connectors serve as the G, B, R and SYNC
input connectors.
SYNC (4 V or 0.3 V) or G-ON-
SYNC can be selected using the INPUT VIDEO
item of the setup menu.
The 75 Q selector switch must be used at the ON
position.
Component mode:
The connectors serve as the composite video
signal and component signal (Y, Ps, PR) input
connectors.
Whether they are to be used as
composite or component connectors is selected
using the INPUT VIDEO item of the setup menu.
The REF VIDEO signal can also be input.
When
composite signals are distributed and
input to the composite input connectors and REF
VIDEO connector (by using T-shaped connectors
for the composite input connectors), set the 75 2
selector switch to the OFF position.
If component signals are to be recorded or if the
REF
VIDEO
signal
is to be
supplied
from
different systems even when composite signals
are to be recorded, the 75 Q selector switch must
be used at the ON position.
17
@S-VIDEO input connector (4P)
This is the input connector for the S-VIDEO (Y/C)
signal.
It is selected using the INPUT VIDEO item of the
setup menu.
6) RGB/composite/component
(Y, Pa, Pr) video
output
connectors
(BNC
x3)
and
SYNC
connector (BNC x1)
RGB mode:
The connectors serve as the G, B, R and SYNC
output connectors.
Component mode:
The connectors serve as the composite video
signal and component signal (Y, Ps, PR) output
connectors.
Which signals are to be output is
selected using the OUTPUT VIDEO item of the
setup menu.
© S-VIDEO input connector (4P)
This is the output connector for the S-VIDEO (Y/C)
signal.
Advertisement
Table of Contents
