Table of Contents
Advertisement
Operation
4. Searching
4-1. Direct searches using address values
(DIRECT search)
1. Press the SEARCH button.
The search input screen appears on the display.
The condition settings (ID, DATE and TIME) in the
bottom part of the screen are not used.
< SEARCH CONDITION INPUT >
ADDRESS
:
000000
INPUT CONDITIONS
and SET: GOTO
2. Input the desired address value, and then initiate
the search.
After entering the address value in the ADDRESS
input area, press the SET button.
When inputting the address, use the left and right
arrow buttons to move to the digits, and use the "+"
and "—" buttons to input the numbers.
After a frame has been searched, it is played back
automatically.
Address values which can be used
RGB mode:
1 to 1680
Component mode:
1 to 3300
When
the SET
button
is pressed
with zeros
displayed, address 1 is searched.
4-2. Searching the last recording address
(END search)
When the END button is pressed (when the "+" button
is pressed while holding down the SHIFT button), the
frame recorded at the last address on the disc is
searched and played back.
4-3. Searches by inputting the search
conditions
1. Press the SEARCH button.
The search input screen appears on the display.
The ADDRESS setting area in the top part of the
screen is not used.
< SEARCH CONDITION INPUT >
ADDRESS
:
000001
INPUT CONDITIONS
and SET : SEARCH
. Input the search conditions.
The search conditions which can be input are ID,
NAME,
NAME2,
DATE
and TIME.
(Only one
condition from among ID, NAME and NAME2
is
selected for use.)
Searches can be conducted using one condition
such as ID or DATE or AND searches combining
the
DATE
and
TIME,
for
instance,
can
be
performed.
Refer to the points below for further
details on the search conditions.
OS Concerning the search conditions
1) A condition is ignored when nothing has been input
for that item.
By pressing the CLR
button, a
condition can be cleared after an item has been
selected by the cursor.
2) Only one condition from among
ID, NAME
and
NAME2 can be selected.
To select the condition, bring the cursor to the ID,
NAME
or NAME2
display area on the search
screen (in the above figure, the area where ID is
displayed).
The condition can be switched
in
succession by pressing the SHIFT button and right
arrow button together.
While conducting a remote control operation, ID,
NAME or NAME2 can be selected in sequence by
pressing the VOICE PLAY button or VOICE REC
button.
3) AND
searches
combining
one
condition
from
among ID, NAME and NAME2 with DATE or TIME
can be performed.
For instance, by inputting ID
and DATE, the frame with a specific ID and specific
date can be searched.
Advertisement
Table of Contents
