Table of Contents
Advertisement
General Introduction
@ Monitor (MONITOR) output connector (BNC)
This
is the
composite
video
signal's
output
connector used for monitoring.
In the NEXT mode,
the next frame is output.
In any other mode, the
same frame as the one output from the other video
output connectors is output.
GEXT-REMOTE connector
This enables the unit to be operated by remote
control from an external source.
(MIS 6-6 bit control)
@RS-232C connector
The unit can be operated by remote control using a
device complying with the RS-232C standard.
Set the front panel LOCAL/REMOTE switch to
REMOTE for use.
() GPI connector
This is a 7-input/7-output
parallel input/output
connector.
The input/output signals are set on the setup menu.
Set the front panel LOCAL/REMOTE
switch to
REMOTE for use.
( SCSI connector
|
Frames can be copied and backups of discs can be
made by connecting an external designated DVD-
RAM drive to this connector.
The DIP switches on the external drive and unit's
rear panel must be set to SCSI.
(DDIP switches
These are used to perform settings for the unit.
(See page 21)
@ Battery compartment cover
This is the cover of the compartment housing the
battery for the internal clock.
@ Equipotential terminal }
When connecting this unit to any other component,
make absolutely sure that it is properly grounded by
connecting this terminal.
When connecting, use the terminal lug, and be sure
to used wire with a cross-sectional area of at least
1.0 mm?.
Cross-sectional Area:
Terminal Lug
More than 1.0 mm?
18
3-3. Wired remote controller
USD
Kia
PICTURE
(a)
ine)
©
For details on the functions
of the wired
remote
controller's buttons, refer to the descriptions of the
corresponding buttons on the unit.
The
main
differences
between
the wired
remote
controller's buttons and unit's buttons are as follows.
e On the unit's front panel, some
functions are
implemented by pressing a button while holding
down the SHIFT button.
On the wired remote
controller, separate buttons are provided.
ID button
CHARACTER button
END button
OVERWRITE button
VOICE PLAY button
VOICE REC button
e The wired remote controller has ten number keys to
make it easier to input numbers.
e Search dial
Rotating the inner dial clockwise initiates a forward
operation; conversely, rotating it counterclockwise
initiates a reverse operation.
The outer dial is not functional.
Advertisement
Table of Contents
