Panasonic LQ-D100P Operating Instructions Manual page 23

Digital frame disc recorder
Hide thumbs Also See for LQ-D100P:
Table of Contents

Advertisement

Preparations
Write-protected
Write-enabled
The REC INHIBIT lamp on the unit's front panel lights
up when a disc whose write protect switch is set to
write-protect has been inserted into the unit.
The same lamp will also light when the "REC INHIBIT"
DIP switch on the rear panel has been set to ON.
It is also possible to prevent further recordings onto
already recorded areas by formatting a disc in the
pseudo write-once mode.
The differences in the recording inhibit methods are
outlined in the table below.
Set the write protect switch on the
| The REC INHIBIT lamp on the
Absolutely no more recordings can be made on the disc.
disc cartridge to the write protect
unit's front panel lights.
Since it is the disc itself that is protected from recording, this
position.
method is used when the data on the disc is to be
preserved.
Set the "REC INHIBIT" DIP switch
The REC INHIBIT lamp on the
The unit can no longer perform any more recording
on the rear panel to ON.
unit's front panel lights.
operations.
Set the disc to the write-once mode | The WRITE ONCE lamp on the
Frames which have already been recorded can no longer ba
when it is formatted.
unit's front panel lights.
overwritten.
Data can siill be recorded in the unrecorded areas.
For further details, refer to the setup menu items.
3-3. How to set recording inhibit
The disc cartridge comes with a write protect switch to
prevent any new data from being recorded on the disc
in error.
Cautions:
1. The pseudo write-once function works only when it is used with this unit.
It will not work with a computer or other such device: this means that if the disc is used with a computer, the
destruction of possibly valuable data may resuit. This is why discs on which recordings were made using
this unit should not be used with any other device.
2. To protect a disc — even a pseudo write-once disc -- whose data recording has been finished or which
contains valuable data, the write protect switch of its disc cartridge must be set to the write-protect position.
23

Advertisement

Table of Contents
loading

Table of Contents