Auxiliary Interface Kit - Xerox WorkCentre 6400S System Administrator Manual

Auxiliary Interface Kit

An Auxiliary Interface Kit, or a Foreign Device Interface kit, is a third-party access and accounting
device such as a coin operated printer accessory or a card reader that can be attached to the printer.
Installation instructions are included with the Foreign Device Interface Kit. After the kit is installed, you
must enable Auxiliary Access at the control panel.
Note: If your printer is locked, you must log in as a system administrator. For details, see
Setup at the Control Panel
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Accounting Settings > Accounting Enablement, then touch Accounting Mode.
3. Touch Auxiliary Access.
4. Touch Auxiliary Device Type and select your printer type.
5. Touch Save twice.
To configure accounting, see
To configure authentication, see
on page 15.
Accounting on page 141.
Local Authentication
Customization and Expansion
on page 55.
WorkCentre 6400 Multifunction Printer
System Administrator Guide
Initial
171