Table of Contents
Advertisement
E. PLUMBING PREPARATION
Position the plumbing according to the roughing-in
dimensions. Cap the supplies, and check for leaks.
6. BEFORE INSTALLING UNIT
A. PARTIALLY INSTALL BATH DRAIN
Install the drain on the bath according to the drain
manufacturer's instructions. When installing the drain
overflow tube and hood, be sure to adequately seal
along the edges of the hood to prevent leakage.
B. PROTECT UNIT
Position a drop cloth or similar material in the bottom of
the unit. Be careful not to scratch the surface of the
product.
7. INSTALL THE MODULE
A. MODULE SET-IN
1.
Lay out and mark the supply or mixing valve hole
locations on the back of the unit. Drill a 1/4" (6mm)
diameter pilot hole at each fitting mark.
2.
For multiple-unit installations, where the supply
fittings have been accurately located during the
plumbing rough-in, a template made of lightweight
plywood and containing all the correct pilot holes
can be used to position the holes on the back
surface of the unit.
3.
Use a hole saw to drill the holes required. Drill from
the finished face of the unit.
CAUTION: Risk of product damage. When
moving the unit, do not flex or damage may occur.
4.
Clean the bath recess thoroughly. Carefully slide
the unit into the recess.
AB
114825-2-
8
Kohler Co., Kohler, WI U.S.A.
Advertisement
Table of Contents
