Table of Contents
Advertisement
8. BOLT TIGHTENING SEQUENCE
Remove and save the washers used as spacers. Install
the washers and nuts to the bolts, and tighten the nuts
in the sequence shown.
Remove all excess sealant on the inside of the module.
Remove the tape.
Check the inside joining edge for any excess sealant.
Spread out any excess sealant found along the back
side seam areas. Apply additional sealant along the
back side seam areas.
Check that all nuts and bolts are tightened.
9. BEFORE INSTALLING UNIT
A. PARTIALLY INSTALL BATH DRAIN
Install the drain on the bath according to the drain
manufacturer's instructions. When installing the drain
overflow tube and hood, be sure to adequately seal
along the edges of the hood to prevent leakage.
B. PROTECT WHIRLPOOL UNIT
Position a drop cloth or similar material in the bottom of
the unit. Be careful not to scratch the surface of the
product.
Kohler Co., Kohler, WI
Area 4
Area 6
Area 2
11
Area 7
Area 3
Area 5
Area 1
BA
116014-2-
(-)
Advertisement
Table of Contents
