Advertisement
INSTALL DRAIN
A. Install the Strainer
·
Apply a ring of plumbers putty or other sealant to the
underside of the strainer according to the putty
manufacturer s instructions.
·
Place the gasket between the drain elbow and the
bottom of the bath.
·
Thread the strainer into the drain elbow. Do not fully
tighten until after the drain elbow and overflow tube
have been installed.
A.
·
·
·
B. Assemble Drain Elbow and Overflow
Tube
·
Assemble coupling nuts and tapered gaskets (note
proper position above) on overflow tube and drain
elbow.
·
For through-the-floor installations, the threaded
portion of the tee points toward the floor. For above-
the-floor installations, the threaded portion of the tee
points away from the drain elbow, as shown above.
·
Align parts with the tee in the proper configuration
for your installation. Make sure the drain elbow tube
is facing the front of the bath. Insert tubes
completely into the tee and hand tighten the
coupling nuts.
·
Tighten the drain elbow securely by inserting pliers
handles into the top of the strainer. The handles will
engage the tabs inside the strainer as it is turned
into the drain elbow.
·
Remove any excess sealant.
B.
·
·
·
·
·
1023725-T01-A
Overflow Tube
Coupling Nuts
Drain Elbow
Overflow Tube
Coupling Nuts
Drain Elbow
4
Gaskets
Tee
Tailpiece
Through-the-floor installations
Gaskets
Tee
Tailpiece
Above-the-floor installations
Black Gasket
Overflow Elbow
Overflow Tube
Advertisement
