Table of Contents
Advertisement
C. INSTALL PLUMBING
CAUTION: Risk of damage to bath bottom and
subfloor. Ensure a watertight seal on the bath
drain connections.
1.
When the bath is securely positioned, connect the
drain to the trap.
NOTE: An access panel will simplify future mainte-
nance.
2.
Install the faucet valving, spout tee, and
showerhead. Open the hot and cold water valves,
and check the supply connections for leaks.
3.
Run water into the bath, and check the drain
connections for leaks.
8. ELECTRICAL CONNECTIONS
A. IDENTIFY ELECTRICAL REQUIREMENTS
The model number is printed on a label at the pump end
of the bath.
The label identifies electrical rating.
B. WIRING INFORMATION – UNITS WITHOUT
WHIRLPOOLS
WARNING: Risk of electrical shock. To reduce
the risk of electric shock, connect only to a properly
grounded, grounding-type receptacle, protected
by a Ground-Fault Circuit-Interrupter (GFCI). Do
not remove the plug's grounding pin. Do not use a
grounding adapter.
The Kohler BodySpa is equipped with a cord and plug.
All wiring of the pump and control has been completed
at the factory. A licensed electrician must install a
GFCI-protected, 120 V, 20 A, grounded outlet. The
BodySpa may then be plugged into this outlet. No other
load should be on this circuit. Locate the outlet behind
the BodySpa, and within 24" (61cm) of the pump.
* For bonding in accordance with national and local
codes.
AB
114825-2-
Switch
Wire
10
Connect Here
20 A
Receptacle
Plug-in
Cord
Bonding
(Earthing) Lug*
Pump
Control Box
Kohler Co., Kohler, WI U.S.A.
Advertisement
Table of Contents
