Table of Contents
Advertisement
B. OPERATING SEQUENCE – BODYSPA
SYSTEM
Refer to the chart at right for the proper operating
sequence.
1.
Turn on the BodySpa by pressing the On/Off button
on the control switch. Water will flow from the six
Body Jets at the lowest flow setting.
2.
Use the
and
arrows to vary the water force.
3.
Press the On/Off button a second time to turn off
the BodySpa.
4.
On units with a whirlpool, press the whirlpool
On/Off. button to turn on the whirlpool, and turn off
the Body Jets.
5.
A built-in timer automatically stops the motor after
approximately 20 minutes of operation.
TE:
NO
The BodySpa and whirlpool functions will not
operate at the same time.
C. START-UP WHIRLPOOL
Refer to the Important Information on Page 2.
Please perform the following so the owner can safely
receive the benefits of whirlpool bathing.
1.
Rotate the jets so they are facing down toward the
basin.
2.
Fill the whirlpool to a water level at least 2" (5.1cm)
above the top of the highest jet.
Water temperature in the bath should not exceed
104_F (40_C).
AB
114825-2-
TO
Turn on the
BodySpa.
Increase water
force, press the
button.
Decrease water
force, press the
button.
Shut off the
BodySpa.
Restart the
BodySpa
after the 20
minute
cycle is
complete.
Bath
2" (5.1cm)
Wall
Minimum
14
METHOD
OBSERVE
Up/
More
Down/
Less
Water Line
Jet Trim
Kohler Co., Kohler, WI U.S.A.
Advertisement
Table of Contents
