Table of Contents
Advertisement
C. WIRING INFORMATION – UNITS WITH
WHIRLPOOLS
WARNING: Risk of electrical shock. To reduce
the risk of electric shock, connect only to a properly
grounded, grounding-type receptacle, protected
by a Ground-Fault Circuit-Interrupter (GFCI). Do
not remove the plug's grounding pin. Do not use a
grounding adapter.
The Kohler BodySpa is equipped with a cord and plug.
All wiring of the pump and control has been completed
at the factory. A licensed electrician must install a
GFCI-protected, 120 V, 20 A, grounded outlet. The
BodySpa may then be plugged into this outlet. No other
load should be on this circuit. Locate the outlet behind
the BodySpa, and within 24" (61cm) of the pump.
* For bonding in accordance with national and local
codes.
9. COMPLETE INSTALLATION
A. INSTALL WHIRLPOOL TRIM KIT
Refer to the installation instructions packed with the trim
kit when installing the jet or suction trim.
B. INSTALL HANDLES AND SPOUT
Install the faucet handles and spout according to the
manufacturer's instructions. Seal around the plumbing
fittings.
CAUTION: Risk of property damage. The
valve, spout, and other plumbing fittings must be
adequately sealed to prevent water leakage
behind the finish wall.
C. INSTALL DOOR ENCLOSURE
Install the K-9846 Door Enclosure according to the
installation instructions included with the enclosure. Pay
special attention to ensure that the door enclosure is
properly adjusted to prevent leakage.
Kohler Co., Kohler, WI U.S.A.
BodySpa
Switch
Auxiliary
Control
Bonding
(Earthing) Lug*
11
Whirlpool
Switch
20 A
Plug-in
Receptacle
Cord
Pump
Control
Box
114825-2-
AB
Advertisement
Table of Contents
