Table of Contents
Advertisement
8. ELECTRICAL CONNECTIONS
A. IDENTIFY ELECTRICAL REQUIREMENTS
The model number is printed on a label at the pump end
of the whirlpool.
The label identifies electrical rating.
S K-1312-N,
K-1312-H1
(Follow Step B. below.)
S K-1312-JB:
(Follow Steps C. and D. below.
See page 6, Electrical Requirements section of
Product Requirements.
B. WIRING INFORMATION – 120 V, 60 HZ –
1-SPEED PUMP – 1-SPEED PUMP –
K-1312-N AND K-1312-H1 MODELS
WARNING: Risk of electrical shock. To reduce
the risk of electric shock, connect only to a properly
grounded, grounding-type receptacle, protected
by a Ground-Fault Circuit-Interrupter (GFCI). Do
not remove the plug's grounding pin. Do not use a
grounding adapter.
Your Kohler Whirlpool bath is equipped with a cord and
plug. All wiring of the pump and control has been
completed at the factory. A licensed electrician must
install a GFCI-protected, 120 V, 20 A, grounded outlet.
Your whirlpool may then be plugged into this outlet. No
other load should be on this circuit. Locate the outlet
behind the whirlpool and within 24" (61cm) of the pump.
* For bonding in accordance with national and local
codes.
Kohler Co., Kohler, WI U.S.A.
120 V, 60 Hz
1-speed pump
230 V, 50/60 Hz
Pump
Switch
Auxiliary
Control
*
Bonding
(Earthing) Lug*
11
Neck Jet
Switch
20 A
Plug-in
Receptacle
Cord
To Neck
Jets
Pump
Control Box
114047-2-
BB
Advertisement
Table of Contents
