Table of Contents
Advertisement
C. INSTALL PLUMBING
CAUTION: Risk of damage to bath bottom and
subfloor. Ensure a watertight seal on the bath
drain connections.
1.
When the bath is securely positioned, connect the
drain to the trap.
NOTE: An access panel will simplify future mainte-
nance.
2.
Install the faucet valving and spout tee. Open the
hot and cold water valves, and check the supply
connections for leaks.
3.
Run water into the bath, and check the drain
connections for leaks.
8. INSTALL GRIP RAILS
Refer to the installation instructions packed with the grip
rail kit when installing the grip rails.
9. ELECTRICAL CONNECTIONS
A. IDENTIFY ELECTRICAL REQUIREMENTS
The model number is printed on a label at the pump end
of the whirlpool.
The label identifies electrical rating.
B. WIRING INFORMATION – 120 V, 60 HZ –
2-SPEED PUMP (UL LISTED) MODELS
WARNING: Risk of electrical shock. To reduce
the risk of electric shock, connect only to a properly
grounded, grounding-type receptacle, protected
by a Ground-Fault Circuit-Interrupter (GFCI). Do
not remove the plug's grounding pin. Do not use a
grounding adapter.
Your Kohler whirlpool bath is equipped with a cord and
plug. All wiring of the pump and control has been
completed at the factory. A licensed electrician must
install a GFCI-protected, 120 V, 20 A, grounded outlet.
Your whirlpool may then be plugged into this outlet. No
other load should be on this circuit. Locate the outlet
behind the whirlpool, and within 24" of the pump.
* For bonding in accordance with national and local
codes.
BA
113906-2-
(A)
Switch
Wire
10
Connect Here
20 A
Receptacle
Plug-in
Cord
Bonding
(Earthing) Lug*
Pump
Control Box
Kohler Co., Kohler, WI
Advertisement
Table of Contents
