Audi R8 2017 Owner's Manual page 17

Table of Contents

Advertisement

(0 )
Brake pads
rlJ
Brake pads: wear limit reached. You can con-
tinue driving. Please contact Service
The brake pads are worn.
Drive to an authori zed Audi dealer or authori zed
Audi Service Facility immediately to have the
brake pads checked.
Applies to: USA models
The
rlJ
indicator light turns on together with the
1111
indicator light
!f
Safety systems
The
fll
indicator light monitors the safety sys-
tems .
Safety system
If the
fll
indicator light turns on or blinks, there
is a malfunction in a safety system .
Drive to an authorized Audi dealer or authorized
Audi Service Facility immediately to have the
malfunction corrected.
A
WARNING
Have the safety systems inspected immedi-
ately. Otherwise, there is a risk that the sys-
tems may not activate during a collision,
which increases the risk of serious injury or
death.
d.:::, Engine control
If the
II/.
indicator light turns on, there is an
engine control malfunction.
Drive slowly to an authorized Audi dealer or au-
thorized Audi Service Facility to have the engine
checked.
o
System indicator light (MIL)
The system indicator light (MIL) is part of the On
Board Diagnostic system (OBD II). The
II
sym-
~
bol turns on when the ignition is switched on and
~
turns off again once th e engine is started and
~
running at a steady idle speed. This indicates that
0
~
the MIL is functioning correctly.
'<f
Instruments
and indicator
lights
The indicator light turns on if there is a malfunc-
tion in the engine electronics. See an authorized
Audi dealer or authorized Audi Service Facility to
have the malfunction corrected .
For additional information, refer to
c::;,
page 17.
!?)
Engine speed limitation
Applies to : vehicles with engine speed limitation
(fl
Engine speed maximum XXXX RPM
The engine speed is automatically limited to the
speed displayed in the driver information system.
This protects the engine from overheating.
The engine speed limitation deactivates once the
engine is no longer in the critical temperature
range and you have released the accelerator ped-
al once.
If the engine speed limitation was activated by
an engine control malfunction, the
II
indicator
light also turns on. Make sure the engine speed
does not go above the speed displayed, for exam-
ple when downshifting. Drive to an authorized
Audi dealer or authorized Audi Service Facility im-
mediately to have the malfunction corrected.
~ " Engine oil level (min .)
El
Please add oil immediately.
Stop the vehicle and add engine oil
c::>
page
22
7.
~
•. Engine oil sensor
Oil level system: malfunction! Please con-
tact Service
The sensor to check the engine oil level has
failed. Drive to an authorized Audi dealer or au-
thorized Audi Service Facility immediately to have
the malfunction corrected .
(I)
Note
Refer to the description in the Owner's Man-
ual
c::;,
page
22
7, Checking the engine oil lev-
el.
15

Advertisement

Table of Contents
loading

Table of Contents