Telephone; Introduction; Setup - Audi R8 2017 Owner's Manual

Telephone
Telephone
Introduction
To make phone coils in your vehicle using the
MMI, connect your cell phone to the MMI via
Bluetooth.
Handsfr ee
Afte r you have connected your cell phone to the
MMI via Bluetooth, you can use the handsfree
system and operate telephone functions through
your MMI. You can make calls using the antenna
on your cell phone.
A
WARNING
- Med ical experts warn that cell phones can
interfere w ith the funct ion of pacemakers .
Always mainta in a m inimum distance of 20
cent imeters between the cell phone anten-
na and the pacemaker.
- Do not carry the cell phone in a pocket di-
rectly over the pacemaker when the phone
is switched on.
- Switch the cell phone off immediately if
you suspect it may be interfering w ith the
pacemaker.
- Do not use the voice recognit ion system
¢
page 102 in emergencies because your
voice may change in stressful situations. It
may take longer to dial the number or the
system may not be able to dial it at all. Dial
the emergency numbe r manua lly.
- Switch your cell phone off in a reas whe re
there is a risk of an exp losion. These loca-
t ions are not always clearly mar ked. This
may include gas stations, fuel and chemical
storage facilities or t ransport vehicles, or lo-
cations where fuel vapors (such as propane
or gasoline vapor in vehicles or bui ldings),
chemicals or large quantities of dust parti-
cles (such as flour, sawdust or metal) may
be present in the air . This also applies to all
othe r locations where you would normally
turn your vehicle engine off .
- The demands of traffic requ ire your full at-
tent ion. Always read the chapter ¢ page 90,
Traffic safety information.
108
(D
Tips
- To learn which Bluetooth connections and
wh ich of the funct ions in your cell phone are
supported, check with your cell phone serv-
ice provider or the database for mobile devi-
ces at www .audiusa.com/ bluetooth .
- The Bluetooth connection range is limited
to inside the vehicle . It can also be affected
by local condit ions and interference with
other devices .
Setup
Connecting a cell phone using Bluetooth
Fig. 97 Disp laying t he PIN for entering in the cell phone
Requirement
The vehicle must be stationary and the ignition
must be sw itched on.
The Bluetooth function and visibility of the MMI
¢ page 164 and cell phone must be switched on.
The cell pho ne to be connected must not be ac-
tive ly connected to any othe r Bluetooth dev ice.
The MMI must not be connected to a cell phone .
Connectin g a cell phone
"' Select:
! MENU I
button> Telephone> Connect
mobile device > Next . The availab le Bluetooth
dev ices are shown in the Infota inment system
disp lay. Or: search for the MMI in your cell
phone through the Bluetooth device sea rch .
"' Sele ct and confirm the des ired cell phone from
the list of d isplayed Bluetooth devices.
"' The MMI generates a PIN for the connection
setup ¢ fig. 97 .
"' Select and confirm Yes.
"' Enter the PIN for connecting on your cell
phone. Or: when the PIN is displayed on your