Table of Contents
Advertisement
"'
"' ....
N
"
N
....
0
0
Vl
'<f
~
Select: left control button >
Directory>
a con-
tact.
The directory/contacts
are shown in alphabetical
order and are marked with symbols to indicate
the storage location:
@
Business address
@
Private address
@
Business destination
©
Private destination
- Select and confirm an address or a destination .
When you have selected a destination,
route
guidance starts immediately.
- Check the address input again when selecting
an address.
- Then select and confirm
Start route guidance.
Additional directory functions in the navigation
system can be found under
c>
page 134 .
{!)
Tips
- Addresses that have been imported from
your cell phone into the MMI can also be
used as a destination.
- If a contact is grayed out in the directory,
this contact does not have a destination or
an address assigned to them.
Entering a point of interest
Fig. 108 Enterin g a point of interest
~
Press the
I
NAV/MAPI
repeatedly until the
Enter
destination
menu is displayed
c>
page 128,
fig. 106 .
~
Select : left control button >
Points of interest.
- Changing the search area:
select and confirm
Search area
> a search area from the list .
Navigation
- Searching for a point of interest in a specific
category :
select:
Select category >
desired cat-
egory,
such as
Restaurants.
The following search categories are available:
Nearby:
points of interest can be selected from
different categories . The points of interest are
listed starting from the vehicle position up to a
radius of approximately 124 miles (200 km).
Along the route :
points of interest along the
route can only be selected during active route
guidance. The points of interest are located di-
rectly along or in the immediate vicinity of the
calculated route.
Near destination/Near stopover:
the points of
interest can likewise be selected from different
categories in the vicinity of the destination or
stopover. For example, you can search for a hotel
or parking lot at the destination.
In new city:
enter the name of the desired city .
Points of interest can be selected from various
categories. This function allows you to search for
points of interest in any city regardless of the ac-
tive route guidance or the vehicle position.
@
Tips
- Distances to points of interest are shown as
a straight-line distance from the vehicle po-
sition. The actual distance from your current
location to the point of interest is updated
automatically. The list of found points of in-
terest is not resorted when this happens.
- There may be entries in the list that cannot
be displayed completely due to their length .
If you select these list entries using the con-
trol knob, detailed information about the
selected list entry will be shown automati-
cally after several seconds.
Point of interest on line search
Appl ies to: vehicles wi th Audi connect
You con search for points of interest on the In-
ternet.
Requirement: the requirements for Audi connect
services must be met
c>
page 119 .
.,.
131
Advertisement
Table of Contents
Troubleshooting
