Omron sysmac EtherNet/IP NJ Series Connection Manual page 19

4
Connect Motor to Encoder
connector (CN2) on Driver with
the encoder cable and to
Motor connector (CN3) on
Driver with the motor cable.
5
Connect Switching hub and
EtherNet/IP communication
connector (CN5) on Driver with
a LAN cable.
Connect Power supply to
Switching hub.
6
Connect Control power supply
to Control power supply input
terminals (CN1) on Driver.
Connect Main power supply
(single-phase 100-120V) to
Main power supply input
terminals (CN4) on Driver.
*For details on the power supply
connection, refer to 4
Connection of the αSTEP AZ
Series/Motorized Actuator
equipped with AZ Series
EtherNet/IP Compatible Driver
USER MANUAL (HM-60372E).
7．EtherNet/IP Connection Procedure
Encoder
connector (CN2)
Motor
connector (CN3)
Motor
Switching hub
LAN cable
Power
supply
Control power supply
input terminals (CN1)
Control power supply
Main power supply
input terminals (CN4)
Main power supply
(single-phase 100-120V)
EtherNet/IP
communication
connector (CN5)
16