Honda HS828 Manual page 51

•
---~
HS928
FL YWHEEUIGNITION COil
1. FLYWHEEL/IGNITION COIL
FlYWHEEL/IGNITION COIL
a.
DISASSEMBLY /REASSEMBLY
HONDA
HSS2S
• Flywheel/ignition coil disassembly/reassembly can be made w1th the engine installed in the frame.
Before disassembly, perlorm the following:
1) Remove the fuel tank/governor (P.
5A).
2) Remove the AC starter switch (P. 18-1 ).
3) Remove the fan cover (P. 6-1 ).
BLACK WIRE
REASSEMBLY:
Install the black wire with two clamps
to the cylinder barrel.
WOODRUFF KEY (25
x
18)
REASSEMBlY:
After reinstalling the flywheel, check
to be sure that the woodruff key is
still in its slot on the crankshaft.
HIGH TENSION CORD
REASSEMBLY:
Check for frayed insulation or other
defects.
6
X
25 (2)
TRANSISTORIZED IGNITION
COil
jtNSPECTION/ADJUSTMENT: P. 7-2
CODliNG FAN
CAUTION:
When disassembling and reassembl-
ing. take care not to damage the fan
blades.
REASSEMBLY:
Attach by aligmng the four lugs on
the rear side of the fan with the small
holes in the flywheel.
FLYWHEEL
DISASSEMBLY:
• Do not hit the flywheel with a
hammer.
Remove with a commercially
avaliable flywheel
puller~
• Avoid the magnet section when
attaching the puller.
FLYWHEEL PULLER
(COMMERCIALLY
AVAILABLE) .
REASSEMBLY:
II
• Make certain there are no metal
objects stuck to the magnets.
• Adjust the ignition coil air gap after
reassembly (P. 7 -2).
16 mm SPECIAl NUT
TORQUE:
113 N-m (11.3 kg-m. 82
ft~lb)
DISASSEMBlY/REASSEMBlY:
• Apply oil to the thread.
• Hold the flywheel by placing
screwdriver into the pulley.
STARTER PULLEY
REASSEMBLY:
Attach by aligning the lug {A) on
the pulley with the small hole (B)
at
the center of the flywheel.
~
tBI IAI