Honda HS828 Manual page 19

9. Overheating
1) Check the hydrostatic transmis-
I
sian fluid level (P. 3-3).
GOOD
2) Make
sure
the recommended
transmission fluid is used in the
hydrostatic transmission.
CORRECT FLUID
3) Check
that the hydrostatic
transmission is clean.
CLEAN
4) Make sure the snowblower is
I
used correctly.
CORRECTLY
10. Hydrostatic transmission fluid leak.
[_Hydrostatic transmission fluid leak.
HS928
•
Hydrostatic transmission
fluid level is low.
•
Wrong fluid
•
Dirty
•
Incorrectly
• Clogged air vent hole of the __...._..__.__.
reservoir of high pressure
inside the reservoir
caused by a high fluid
level.
•
•
•
,.
HONDA
HSB2B
Fill yvith hydrostatic transmission
fluid to the upper lever (P. 3-3).
Check the hydrostatic transmis-
sian for leaks.
Change the hydrostatic trans-
mission fluid to the
recom-
mended fluid.
Clean the hydrostatic transmis-
sian.
Increased negative load by incorrect
use.
e
Advise the operator about correct
use.
•
Internal faults in the hydrostatic
transmission.
Go to page
2-16.
• Glean the air vent hole of the
reservoir.
• Fill the reservoir to the correct
level. (P. 3-3).
• Replace the oil seal with new
one.
e
Loosen the
case
bolts.---~·.f[£i--;•;:-;;R:et;;,g;;-h;;t;;e:;n-;-t;;h;;e;-::-ca;;:s;:e~b;;o;;lt;s-. --~
• Loosen the port bolts or _ _ ~
check valve bolts.
• Faulty
washers
--------1
• Retighten the port bolts. Check
valve bolts or drain bolt.
Damaged washers
of
the drain
bolt
or pump case.
• Replace any damaged parts.
Go to page 2-16.
· - - - - - - - · -
--
- - - - -
- - - - -
I