Honda HS828 Manual page 45

HS928
HONDA
HSS28
b. DISASSEMBLY /REASSEMBLY
Remove the drain bolt and drain the carburetor before disassembling. Fuel vapor or spilled fuel may ignite.
NOTE
• Clean the outside of the carburetor before disassembly.
PILOT JET
REASSEMBLY:
THROTTLE STOP SCREW
I
ADJUSTMENT: p 3-5
I
• Clean thoroughly with compressed air
before installation.
• Lightly lubricate the 0-ring to ensure easy
installation into the carburetor body.
MAIN JET
'«/
i
REASSEMBLY: - - - - - - . . . . . ·
Clean thoroughly with compressed air
before installation.
MAIN JET NUMBER:
#92
FLOAT
REASSEMBLY:
Check for smooth movement after
installation.
c.
INSPECTION
• FLOAT LEVEL HEIGHT
Place the carburetor as shown and measure the distance between
the float top and carburetor body when the float just contacts the
seat without compressing the valve spring.
TOOL:
FLOAT LEVEL GAUGE
07401-0010000
/ Standard float height
13.7 mm (0.54 in)
If the height is out of specification, replace the float and/or the
float valve. Recheck the float height.
CARBURETOR BODY
REASSEMBLY:
Is
T"8oL)
FLOAT LEVEL GAUGE
07401-0010000
~
0-RING