Honda HS828 Manual page 20

HONDA
HSB2B
From page 2-15.
HS9Z8
f - - -
e
Faulty 0-rings - - - - - - • 1
• Replace any damaged 0-rings
(P. 14-3, 4, 5).
• Port bolts
• Check valve bolts
• Control bowl
• Oil seal holder
• Neutral valve
• Faulty oil seal
------~1..:-:R::-e-p-:l-a-ce-:a-n_y_d-;-a_m_a-ge-d-;--o-:il_s_e_a~ll
(P. 14-3, 4, 5).
• Pump case
e
Neutral valve
• Rear transmission case
• Oil seal holder!
------ • Faulty pump case or rear
---llo;a~m;.;a~ged;;d~g~a;sk~e~t;s~o~r~c~a~s~e;s.---l
transmission. • Replace any damaged parts.
b. INSPECTION OF THE HYDROSTATIC TRANSMISSION (HST) FOR INTERNAL FAULTS
CAUTION:
• Clean the surroundings not allow dust. or other foreign materials to enter the hydrostatic transmission before
disassembly or reassembly.
• Disassemble and reassemble of the hydrostatic transmission is in the clean area. Avoid getting dust on the parts.
• Handle the parts carefully to avoid damage.
• When wiping off the oil adhering to the parts, use a
lint~free
paper towel.
NOTE:
• Clean the passages of the hydrostatic transmission with high pressurized air.
• Clean all the parts of the hydrostatic transmission before assembling them.
• Disassembly and repair of the hydrostatic transmission must be done according
to
troubleshooting procedures after
checking the all important factor except the hydrostatic transmission.
·- · - · - - ·
~----·--
1)
Check the control bowl for damage and needle bearing for wear or ___... Replace the damaged parts.
damage.
2) Check the spline between the pump shaft and the
driven
pulley for___.... Replace any damaged or won parts.
wear or damage.
(CONT'D)