Honda HS828 Manual page 44

HONDA
HSB2B
CARBURETOR
SERVICE BULLETIN #10
=>
a.
REMOVAL/INSTALLATION
1) Remove the air cleaner elbow (P. 5-2)
HS928
THROTTLE RETURN SPRING
REASSEMBLY:
• Pass the throttle return spring
through the governor rod and
hook it with its end to small hole of
the carburetor throttle arm.
• Short, straight end goes toward
the carburetor side
FUEL TUBE
INSULATOR PACKING
CHOKE ROD
FUEL VALVE
CARBURETOR
PACKING
INSPECTION: P 5-3
DISASSEMBLY:
CARBURETOR INSULATOR
REASSEMBLY:
• Blow out the passages with compressed air
(30 psi or less) and install, noting the
installation direction.
• After installation, connect the spark plug
wire and fuel tube securely.
HIGH
CORD
Unhook the thronle return spring. Pull the carburetor
forward to a point where the groove in the throttle arm
lines up with the governor rod. and lift the governor rod
out of its hole. Reassembly is in the reverse order of
disassembly.
GROOVE
THROTTLE