Beep Tone Frequencies; Channelized Frequency Display - Kenwood TM-732A Instruction Manual

8. Beep Tone Frequencies
@ Reprogramming the function of the microphone PF
key.
1. Turn the POWER switch OFF.
2. Press and hold the F key and the TONE key then
turn the POWER switch ON.
3. Release the F key and the TONE key.
@ Operation
The chart below lists the tone frequency assigned to
the various display characters.
523.248Hz 880.000Hz A
1 587 .328Hz 987.770Hz B
2 659.248Hz 1046.496Hz Cc
3 698.464Hz 1174.656Hz D
4 783.984Hz | 1318.496Hz E
Pressing the microphone PF key while a frequency is
displayed will cause the radio transmit a series of tones
that correspond to the display frequency.
52
9. Channelized Frequency Display
The frequency display can be changed to display
channel numbers instead of the operating frequency.
This function makes use of the data you have stored in
memory for this function. Channel 1 is memory
channel 1, Channel 2 is memory channel 2, etc.
1. Turn the POWER switch off.
2. Press and hold down the REV key, then press the
POWER switch.
Channel number are displayed for both bands, and
the U indicator lights for the UHF band.
"CHEE
y CHO |
oe TONE TALT 1_Revsee M mt
f o GS
PoweR
Low
IM
O °
JUTE ABC)
3.. The channel number can be changed with the
tuning control or microphone UP/DWN key when the
BAND SEL key for the desired band is pressed.
To return to the normal frequency display, perform
steps 1 and 2 again.