Kenwood TM-732A Instruction Manual page 23

Example: Select a frequency of 145.640 MHz
bi Press the upper BAND SEL key on the transceiver
to select the VHF band.
2. Press the DTMF Microphone PF key
The VHF frequency display will show: 1--.---.
(14 - .---.: except U.S.A, CANADA version)
3. Press the 4, 5, 6, 4,0 keys on the DTMF keypad in
sequence.
NOTES
ae
2
If no key is pressed within 10 seconds of pressing the PF key the
operation will self cancel.
If the PF key is pressed while entering the frequency, or any key
other than the PF key or numeric keys is pressed the frequency
display will revert to the frequency that was displayed before the
PF key was depressed.
. lf an invalid number key is pressed during frequency entry (Such
as 19X.XXX.) the closest valid key value will be entered. (Using
the previous example the radio would enter a 7, since this is the
closest valid entry for the 10 MHz position.)
. lf aninvalid numeric key is pressed, the value nearest to that
number is entered.
@CALL key VFO key MR key
These keys function just like the CALL, VFO, and
MR keys on the front panel of the radio.
(See page 15.)
© Reprogramming the function keys on the
DTMF Microphone.
1. Hold down the desired key and turn the
transceivers power switch ON.
When the PF key is selected "PF1" will appear in
the display. When the MR key is selected "PF2"
appears. When the VFO key is selected "PF3"
appears, and ""PF4" appears when the CALL key is
selected.
2. Pressing any valid control key sequence will cause
that sequence to be assigned to the corresponding
microphone key.
@ Basic functions performed by pressing a panel
key
@ Function performed when the F key is pressed,
and a panel key pressed within 10 seconds
@ Function performed when the F key is held down
for at least one second, and a panel key pressed
while the F indicator is flashing
@ Function performed when the F key is held down,
and a panel key pressed
23