Cancelling Signal Squelch - Kenwood TM-732A Instruction Manual

3-4. Code Lockout
Codes are locked out only for receive during the
Paging Mode.
It is possible to temporarily disable Paging Code
Memories 1,2,3,4, and 5 during receive. This will allow
you to more closely control which individuals, or groups
can open your squelch at any given time.
Paging Code Memories 0 and A cannot be locked out.
Locking out a particular code for receive will not
prevent the code from being transmitted, should you
select that particular Code Memory.
@ Code Lockout
1. Perform steps 1 to 4 on page 66.
2. Select the Paging Code Memory Channel number
you wish to lock out by using the tuning control or
the microphone UP/DWN key.
3. Press the MR/M key.
A *will appear to the left of the Paging Code
Memory Channel indicator to remind you that you
have locked out this code memory for receive.
SZ
3. To restore the code memory for receive use repeat
steps 1 thru 3 above.
68
3-5. Cancelling Signal Squelch
Squelch will not open when operating in the paging
mode when the paging codes do not match. It is
possible to reprogram the transceiver so that squelch
will open regardless of the incoming page code. Signal
_type squelch can be cancelled for each band, if desired.
@ Cancelling signal type squelch
1. Turn the POWER switch off.
2. Hold down the BAND SEL key for the band for which
signaling squelch is to be canceled, then press the
POWER switch.
Even when signal squelch is canceled, a beep sounds
and the individual code of the remote station is
displayed when the proper code is received.
To return signal squelch to the original state, repeat
steps 1 and 2.