Beep Tone - Kenwood TH-225A Instruction Manual

Ш SCAN
Scan is initiated by pressing the key
The transceiver will stop on a busy channel. When an in-
coming signal is detected during scanning, the BUSY i n -
dicator will light. In order for this function to operate the
SQL control must be adjusted to the threshold point. Scan
direction can be selected by
either the [4] or the [7]
key before initiating scan.
The selected scan mode and scan stop mode indicators will
flash ON and OFF during scanning.
* SCAN MODES
1. BAND SCAN MODE: Scans the entire band.
2. MEMORY SCAN MODE: Scans the memory channels
repeatedly, skipping the vacant channels.
3. PROGRAMMABLE BAND SCAN MODE: Scans between
the frequencies stored in memory channels 8 and 9.
If the frequency stored in memory channel 8 is the same
ог greater than in memory 9, or if either or both chan-
nels are vacant, scan will proceed over the entire band.
if SCAN is initiated while the displayed frequency is out-
side the range specified in memory channels 8 and 9, scan.
will proceed outside of the programmed limits.
In the BAND SCAN and PROGRAMMABLE BAND SCAN
MODE, scan proceeds according to the selected step size.
1. SEEK OPERATED SCAN: Scan will stop on a busy chan-
nel. Scan will not resume until the Ex] key is pressed
again.
4
2. TIME OPERATED SCAN: Scan will stop on a busy chan-
nel and resume approx. 5 seconds afterwards. Scan wil
resume even if the station is still present.
Releasing scan: Press one of the following keys during scan-
ning to clear the scan mode.
а) E key b) Ez]. switch
И BEEP TONE
Ss EDI